NMEA 2000 Micro-C Auto pilot network starter kit: Includes Network power cable, 4.5 m (15 ft) N2K cable, 3 x T-connectors, and 2 x network terminators.

NMEA 2000® starter kit - Backbone required to install one or more NMEA 2000® devices includes Network power cable, 0.6 m (2 ft) N2K cable, 4.5 m (15 ft) N2K cable, 2 x T-connectors, 2 x network terminators

N2K-T-RD - Micro-C T-connector for connection of an additional network device

Low loss NMEA2000 4-way joiner. Connect four NMEA2000 Micro-C devices to the NMEA2000 Network.

N2KEXT-2RD - 0.61 m (2-ft) NMEA 2000® cable for backbone extension or drop cable to connect an additional network device

N2KEXT-6RD - 1.82 m (6-ft) NMEA 2000® cable for backbone extension or drop cable to connect an additional network device

N2KEXT-15RD - 4.55 m (15-ft) NMEA 2000® cable for backbone extension or or drop cable to connect an additional network device

N2KEXT-25RD - 7.58 m (25-ft) NMEA 2000® cable for network backbone extension only

NMEA 2000 Micro-C Medium duty cable. 2 m (6.5 ft) Low loss 18 gauge cable recommended for network backbone runs

NMEA 2000 Micro-C Medium duty cable. 6 m (19.7 ft) Low loss 18 gauge cable recommended for network backbone runs

NMEA 2000 Micro-C Medium duty cable. 10 m (33 ft) Low loss 18 gauge cable recommended for network backbone runs

NMEA 2000 Micro-C Medium duty cable. 20 m (65.6 ft) Low loss 18-gauge cable recommended for network backbone runs resulting in a more robust network. Cables are identified by orange locking collars.

In-Line 120-Ohm NMEA2000 terminator, to use in one end of the network.

TR-120-KIT - Set of 1 male and 1 female NMEA 2000® terminators

N2K-PWR-RD - NMEA 2000® power cable. Includes power cable and 1 x T connector

CZONE™ Network Bridge Interface - Designed to isolate sections of the NMEA 2000 network to decrease standby current draw. Can be used for Isolation when bridging between two CAN networks.

Network power isolator. Separates separately powered sections of the NMEA2000 network while letting data through.

20 m (66 ft) NMEA2000 Wind vane cable (Micro-C male - Simnet)

35 m (115 ft) NMEA2000 Wind vane cable (Micro-C male - Simnet)

Evinrude engine interface cable 4.5 m (15 ft) and T-connector

Yamaha engine interface cable 4.5 m (15 ft) and T-connector

NMEA2000 Cable with 90-degree connectors on both ends. For use on instruments mounted in tight spaces etc where normal cables run too deep behind the unit.