TIE DOWN STRAP KIT

HDS-16 CARBON BRACKET ACCESSORY

Lowrance HDS-16 PRO with ActiveImaging™ HD 3-in-1 transducer. 16" SolarMAX HD IPS display, Dual 1kW sonar with CHIRP. Networkable to Lowrance performance sonars (ActiveTarget™ and ActiveTarget™2), Radars, Trolling Motors, and Autopilots along with waypoin

ActiveTarget trolling motor mounting kit. Forward / down view

ELITE FS 9 with No Transducer (ROW) The new Elite™ Fishing System (FS) gives you access to the full line-up of Lowrance fishfinding tools – including ActiveTarget™ live sonar, Active Imaging™, FishReveal™ and preloaded C-MAP® Contour™ + charts – all at a

5/8”-18 Slide hammer adapter

OUTER SHAFT

HDS-9 PRO Bezel and SD Door

ActiveImaging™ HD 3-in-1 (High/Wide)– SideScan Fish Reveal. Delivers the highest-definition views of CHIRP, SideScan™, and DownScan Imaging™ in one transducer + SideScan Fish Reveal when connected to an S3100 sonar module.

ActiveImaging™ HD 3-in-1 (Medium/High)– SideScan Fish Reveal. Delivers the highest-definition views of CHIRP, SideScan™, and DownScan Imaging™ in one transducer + SideScan Fish Reveal when connected to an S3100 sonar module.

HDS-10 PRO Suncover

Lowrance HDS-12 PRO, No Transducer. 12" SolarMAX HD IPS display, Dual 1kW sonar with CHIRP, ActiveImaging™ HD ready. Networkable to Lowrance performance sonars (ActiveTarget™ and ActiveTarget™2), Radars, Trolling Motors, and Autopilots along with waypoint

ActiveTarget™2 kit Includes Module,Transducer with 7.62 m (25 ft) cable, and Mounts

COLLAR CLAMP KIT V.1.1

SUNCOVER: ELITE-9 FS

SUNCOVER: ELITE-7 FS

Replacement - ActiveTarget Trolling Motor Scout Mount Kit

ActiveTarget trolling motor shaft mounting kit

The Prop Shaft Anode for the Lowrance Ghost® trolling motor allows for use in brackish water without voiding the Lowrance Ghost trolling motor warranty. The Prop Shaft Anode is a ring-shaped fitting that is installed over the existing propeller nut, on th

Pushrod kit, GHOST 52”/GHOST 60”: 1x Clevis bracket, 4x Screw, M5x8mm, hex, button, SS, 1x Pushrod, finish machine with bushing, GHOST 52”/GHOST 60”

2x Nose cone O-ring, 1x Cable tie/heat shrink kit (not shown in the illustration), 1x Column, inner, GHOST 60”/lower unit (pre-assembled)

HDI Skimmer® transducer 83/200/455/800kHz for Hook2* and Hook Reveal, with built in temp. Includes mounting bracket and hardware. Cable Length 6m (20 ft). Connector: 8 pin push fit. (*83 kHz / Mid CHIRP frequency options are not available on Hook2)

GHOST 47" MOUNT ASSEMBLY KIT

10lb. weight for shaft bearing pre-load