1x Column, inner shaft, 52"

1x Column, inner shaft, 60"

360 Head HW kit: 2x Screw, SHCS M8 x 1.25 x 20

Propeller hardware kit: 1x Thrust washer, 1x Propeller pin 1x M10 Propeller washer 1x M10 Nylock nut

1x Column, inner shaft, 47"

OUTER SHAFT

1x Lower housing assy with outer column, GHOST 47", 1x Cable tie/heat shrink kit (not shown in the illustration), 2x Screw, M3 x 10, torx, 1x PCBA thermal pad

Bearing, sealed kit: 2x Bearing sealed, 2x Bearing wedge, 1x Seal, shaft, 1x Cable tie/heat shrink kit

Bearing cup: 1x Bearing cup

Lower bearing clamp kit: 2x Collar, lower, 2x Screw, M5x20 mm, hex

Upper clamp kit: 1x Collar, plain, upper, 1x Collar threaded, upper, 2x Screw, M4x25 mm, hex, socket, SS316

Shaft seal: 1x Seal, shaft

Nose cone hardware kit: 1x O-ring, 15x3.53mm, 1x O-ring, 41x2.62mm, 1x Nose cone cap, 1x Bolt, transducer, 2x O-ring, 84x4.10mm

Rod, stabilizer kit: 1xRod, stabilizer, 1x Nut, 3/4"-10, nylon, 1x Foot, stabilizer, 1x Top cap

COLLAR CLAMP KIT V.1.1

360 HEAD ASSEMBLY V.1.1

ROD,STABILIZER HARDWARE KIT

Magnobond Epoxy: 1x Magnobond Epoxy 63-1 50 ml