20 m (66 ft) NMEA2000 Wind vane cable (Micro-C male - Simnet)

HS70 Programming Cable

HS70 NMEA0183 & Power Cable - 15m

Suncover / protective cover for AP70mk2. Also fits AP80, MX610 and MX612.

NF80/FU80/QS80 bulkhead Mounting Kit

SD80 Solenoid Drive PCB for on/off or proportional control of rudder or thruster using galvanic isolated solenoids or high level current. To be mounted in AC85 Autopilot Computer Cabinet.

AD80 Analog Drive PCB for rudder/thruster, to be mounted in AC85 Autopilot Computer cabinet.

Mast Bracket kit with rubber gasket and screws for the WS310/320, 608/508, and IS20 Wind Sensors.

Accessory plug assembly for DST800

RJ45-Yellow Round Ethernet adapter cable RJ45M / 5PinF for products with waterproof RJ45 socket.

SI80 Signal Interface - Four channel NMEA 0183 interface computer board and voltage supply for CAN bus.

SPARES KIT FOR T1/T2 BLACK RAMS

50/200kHz Skimmer™ transducer mounting kit

VKIT-9 Flush Mount Kit for RS10, RS12 and RS25

WTP3 Analogue Module - Provides analogue data acquisition, and includes a range of input and output options to support a wide variety of sensors.

WTP3 Serial Module - Provides serial data acquisition, and includes a range of input and output options to support a wide variety of sensors.

Dual frequency DSI DownScan Skimmer® transducer 455/800kHz with built in temp. Includes 20ft cable, mounting bracket and hardware.

SD80 Solenoid Drive Module for on/off or proportional control of rudder or thruster using galvanic isolated solenoids or high level current.

AD80 Analog Drive Module for analog signal control of rudder or a thruster using analog voltage or low level current.

NF80 Non Follow Up remote unit with display. Take command and Mode buttons. Provides course change in Auto mode.

FU80 Follow UP remote unit with display. Take command and Mode buttons. Provides course change in Auto mode.

WS80 Ultrasonic Wind Sensor. Providing wind data in an NMEA0183 data format via RS485 (RS422) data interface. Built to IP66 Rating.

7pin adapter cable to bare wires. To connect a bare-wire transducer to a display with 7pin sonar port.

TR-120-KIT - Set of 1 male and 1 female NMEA 2000® terminators