CZONE™ Network Bridge Interface - Designed to isolate sections of the NMEA 2000 network to decrease standby current draw. Can be used for Isolation when bridging between two CAN networks.

5 Pin Ethernet cable joiner (Female to Female). Lets you join together two lengths of 5-pin Ethernet Cables. 14 cm (5.5")

NMEA 2000 Micro-C Auto pilot network starter kit: Includes Network power cable, 4.5 m (15 ft) N2K cable, 3 x T-connectors, and 2 x network terminators.

35 m (115 ft) NMEA2000 Wind vane cable (Micro-C male - Simnet)

20 m (66 ft) NMEA2000 Wind vane cable (Micro-C male - Simnet)

RF25N Rudder Feedback Unit With transmission link and 5 m (16.5 ft) NMEA2000 Micro-C cable and T joiner.

FLUSH MOUNT KIT: 3" ELITE/HOOK

HS70 Programming Cable

NMEA2000 Cable with 90-degree connectors on both ends. For use on instruments mounted in tight spaces etc where normal cables run too deep behind the unit.

KAYAK SCUPPER HOLE TRANSDUCER MOUNT

Suncover / protective cover for AP70mk2. Also fits AP80, MX610 and MX612.

AC70 spare PCB assembly. Also option for Voith Schneider propeller control. To be mounted in AC85 Autopilot Computer Cabinet for IMO approved Voith Schneider pilot.

RF70N Medium-duty rudder rudder feedback unit. NMEA2000 interface, comes with transmission link and pre-attached 5.5m cable.

AP70MK2 Bracket Mount Kit. Also for AP70/AP80/MX610/MX612/GN70.

NF80/FU80/QS80 bulkhead Mounting Kit

SI80 Signal Interface PCB with 4 NMEA 0183 RX/TX ports, built-in 12V N2K Network supply. Power input 12-24V DC.

SD80 Solenoid Drive PCB for on/off or proportional control of rudder or thruster using galvanic isolated solenoids or high level current. To be mounted in AC85 Autopilot Computer Cabinet.

AD80 Analog Drive PCB for rudder/thruster, to be mounted in AC85 Autopilot Computer cabinet.

SUNCOVER: 3" MARK/ELITE/HOOK

MOUNTING BRACKET, NSS-12 EVO2, ZEUS2-12

SI80 Signal Interface - Four channel NMEA 0183 interface computer board and voltage supply for CAN bus.

WTP3 Analogue Module - Provides analogue data acquisition, and includes a range of input and output options to support a wide variety of sensors.

WTP3 Serial Module - Provides serial data acquisition, and includes a range of input and output options to support a wide variety of sensors.

Low profile trolling motor mount for use with DSI Skimmer transducer. Includes trolling motor snap on mount, stainless steel trolling motor clamp, and 2 zip ties.