MO24-T - 24" Multi-Touch monitor with 1920x1080 resolution. The 1000 nit peak brightness gives you a clear display even in direct sunlight, and the minimum brightness is extremely dim for night operation without blinding. Multiple video inputs and low-pro

MO19-T - 19" Multi-Touch monitor with 1366x768 resolution. The 1000 nit peak brightness gives you a clear display even in direct sunlight, and the minimum brightness is extremely dim for night operation without blinding. Multiple video inputs and low-prof

MO16-T - 15.6" Multi-Touch monitor with 1366x768 resolution. The 1000 nit peak brightness gives you a clear display even in direct sunlight, and the minimum brightness is extremely dim for night operation without blinding. Multiple video inputs and low-pr

HDMI monitor video cable 3 m (9.8 ft)

NSOevo2, NSOevo3S, Zeus2 and Zeus3S NMEA0183 and Touch Monitor Serial Cable. 2m (6.5 ft)

RJ45-Yellow Round Ethernet adapter cable RJ45 Male / 5 Pin Female 10 cm (6")

SonarHub Module, with power cable and Ethernet cable 4.5m (15ft). Requires adapter 000-12571-001 or 000-13977-001 adapter cable to use Airmar Non-Chirp or Chirp 9-pin transducers.

HDS-8 TO HDS-9 TOUCH DASH MOUNT ADAPTER

MAST MOUNT ADAPTOR KIT

SUNCOVER: 7" ELITE/HOOK

The ZG100 GPS Antenna with Integrated Compass sensor providing Heading, Heel and Trim.

Point-1 GPS antenna provides extremely accurate and rapid boat position and speed updates to the network. Built in magnetic compass provides chart stabilization and radar overlay, plus accurate course over ground even at low speeds. Note: For Autopilot, u

GS25 Antenna with built-in rate compass. 10 Hz position update rate. Built-in rate compass is perfect for providing heading data for Radar Chart Overlay and for orienting charts in Head-Up Mode. Note: This heading sensor is not recommended for MARPA or A

Gimbal mounting bracket with knobs for 12" HDS Gen2 Touch/HDS Gen3/HDS Carbon/Elite-Ti

Gimbal mounting bracket with knobs for 9" HDS Gen2 Touch/HDS Gen3/HDS Carbon/Elite-Ti/Hook/Elite-HDI-CHIRP

Gimbal mounting bracket with knobs for 7" HDS Gen2 Touch/HDS Gen3/HDS Carbon/Hook/Hook2/Hook Reveal/Elite-HDI-CHIRP *Not for use with Elite-7 Ti

Flush Mounting kit for all Elite-7

HDI TROLLING MOTOR ADAPTOR FOR SKIMMER (*only for 83/200/455/800 HDI Skimmer transducer)

HDI Skimmer® transducer 50/200/455/800kHz with built in temp. Includes mounting bracket and hardware. Cable Length 6 m (20 ft)

HDI Skimmer® transducer 83/200/455/800kHz with built in temp. Includes mounting bracket and hardware. Cable Length 6m (20 ft)

Mark/Elite Tallon Mounting kit

Mark/Elite Tallon Mounting kit

CABLE,BB RADAR,EXTERNAL,5M

CABLE,BB RADAR,EXT EXTENSION,2M