Pushrod kit, GHOST 47" 1x Clevis bracket 4x Screw, M5x8mm, hex, button, SS 1x Pushrod, finish machine with bushing, GHOST 47"

Rear latch kit: 1x Mount rear latch 1x Pin, rear latch pivot

Lower dressing cap kit: 1x Lower dressing cap, 1x Spring, latch extension

Upper dressing cap kit: 1x Upper dressing cap, 1x Lock pin upper extrusion, 1x Screw, M6x16, hex, flat, SS

Wear bearing kit, GHOST 47": 2x Wear bearing, GHOST 47"

Side plate kit, GHOST 47": 1x Cover mount RH, GHOST 47", 1x Cover mount LH, GHOST 47", 6x Screw, SHCS M4 x 0.7 x14, SS

Kicker kit: 1x Front kicker, 2x Screw, SHCS M6 x 1 x 8

Cable management clip kit: 2x Cable management clips, 2x M4 x 8 socket screw with patch, 2x M4 round base weld nut

Pull cable kit: 1x Pull cable, 1x Handle bottom, 1x Handle top, 1x Barrel, pull cable, 2x Set screw, M4.0 x 0.7 x 6

Stabilizer, rubber foot: 1x Foot, stabilizer

Rod, stabilizer kit: 1xRod, stabilizer, 1x Nut, 3/4"-10, nylon, 1x Foot, stabilizer, 1x Top cap

Nose cone hardware kit: 1x O-ring, 15x3.53mm, 1x O-ring, 41x2.62mm, 1x Nose cone cap, 1x Bolt, transducer, 2x O-ring, 84x4.10mm

HDI Nose cone transducer: Traditional 200 kHz High Chirp, 83 kHz Medium Chirp and DownScan 455 kHz, 800 kHz

NOSECONE,NOXD

Cable tie/heat shrink kit: 6x Cable tie anchored, 12x Cable tie small, 2x Heat shrink tubing 1.5”

Shaft seal: 1x Seal, shaft

Slip gear assembly: 1x Gear assembly, 2x Screw, M3 x 20, torx

Steering motor thermocouple kit: 1x Cable assembly thermistor 150 mm, 1x Thermocouple adhesive, 1x PCBA thermal pad

Thermal pad, PCBA: 1x PCBA thermal pad

Thermal pad, steering motor: 1x Motor thermal pad

Tensioning bolt kit: 1x Screw, M5x20 mm, hex, socket, SS316, 1x Seal, adjusting screw, O-ring

Steering motor kit: 1x Motor assembly, 1x Motor thermal pad, 1x PCBA thermal pad, 1x Screw, M5x20 mm, hex, socket, SS316, 1x Seal, adjusting screw, O-ring, 4x Screw, M3 x 10, torx, 1x Motor belt

Head sensor assy: 1x Sensor assembly, 2x Screw, M3 x 10, torx

1x Idler, gear, pully, assembly