GHOST MOUNT HARDWARE KIT

ActiveTarget Transom Mount Kit (Not included in the ActiveTarget Kit)

1x Column, inner shaft, 52"

1x Cable, head to pedal, GHOST GHOST 52”, 2x Screw, M3 x 10, torx, 1x Seal, strain relief, 1x Cable tie/heat shrink kit, 1x PCBA thermal pad

1x Cable, head to pedal, GHOST 52”, 2x Screw, M3 x 10, torx, 1x Seal, strain relief, 1x Cable tie/heat shrink kit, 1x PCBA thermal pad

1x Lower housing assy with outer column, GHOST 60”, 1x Cable tie/heat shrink kit (not shown in the illustration), 2x Screw, M3 x 10, torx, 1x PCBA thermal pad

1x Lower housing assy with outer column, GHOST 52”, 1x Cable tie/heat shrink kit (not shown in the illustration), 2x Screw, M3 x 10, torx, 1x PCBA thermal pad

GHOST 47" MOUNT ASSEMBLY KIT

B&G Nemesis™ 12" Sailing Display. The Ultimate sailing display providing visibility & versatility, complete customization and total integration.

GHOST Trolling motor compass extension cable, 6 m (20')

Lift assist crutch: 1x Lift assist crutch

10lb. weight for shaft bearing pre-load

M32 Hollow tap for composite shaft replacement.

5/8”-18 Slide hammer adapter

Magnobond Epoxy: 1x Magnobond Epoxy 63-1 50 ml

B&G Zeus³S-12 and Halo20+ Radar kit. The B&G Zeus³S-12 is an easy-to-use chartplotter navigation system for blue water cruisers and regatta racers, incorporating a 12-inch touchscreen display, high-performance electronics, and a wide range of functionalit

Lower unit rotor assembly: 1x Rotor assembly

Switch housing kit: 1x Switch housing, pedal, 2x Screw, no. 6x3/8, Phillips, pan, SS

Housing, lower, pedal kit, 47”: 1x Base, pedal, 1x Wiper seal, pedal, 3x Grommet wires pedal, 1x Cable tie/heat shrink kit (not shown in the illustration), 1x Misc. hardware, pedal kit

Damper gear assembly kit: 1x Damper gear assembly, 1x Screw, cap, M4x16, 1x Screw, no. 6x3/4, torx, pan, ss

Damper kit: 1x Damper, pedal, 1xScrew M4X8 socket cap head S/S 304, 1x Washer M4 flat OD 12mm SST, 1x PSA washer damper

Label, battery: 1x Label status panel w/adhesive, pedal

PCBA, battery kit, 1x PCB TST ASY power/battery potted, 1x Cable tie/heat shrink kit, 3x Screw 7 mm torx T8

Bottom plate, pedal kit: 1x Bottom plate, pedal, 2x Screw, M5x10 mm, hex, button, SS316, 8x Screw, no. 6x3/4, torx, pan, SS, 4x Rubber foot pedal