Your cart is currently empty
Miscellaneous hardware kit for GHOST Trolling motor foot pedal
Battery power cable kit: 1x Power cable, 2x Screw, M5 x 10 mm, hex
Center cover kit: 1x Center cover, pedal, 1x Screw, no. 6x3/8, Phillips, pan, SS
GHOST foot pedal Configurable button 3.1 x Back right button assembly, pedal, 1x Spring, compression, 7mm ID x 15mm x 1m.
GHOST foot pedal Configurable button 2 kit. 1 x Back left button assembly, pedal, 1x Spring, compression, 7mm ID x 15mm x 1m.
GHOST foot pedal Configurable button 1 kit. 1 x Front left button assembly, pedal, 1x Spring, compression, 7mm ID x 15mm x 1m.
Housing, lower, pedal kit, 47”: 1x Base, pedal, 1x Wiper seal, pedal, 3x Grommet wires pedal, 1x Cable tie/heat shrink kit (not shown in the illustration), 1x Misc. hardware, pedal kit
PCBA, battery kit, 1x PCB TST ASY power/battery potted, 1x Cable tie/heat shrink kit, 3x Screw 7 mm torx T8
Bottom plate, pedal kit: 1x Bottom plate, pedal, 2x Screw, M5x10 mm, hex, button, SS316, 8x Screw, no. 6x3/4, torx, pan, SS, 4x Rubber foot pedal
Pedal PCBA, potted assembly kit: 1x Potted main controller assembly, pedal, 1x Cable tie/heat shrink kit, 6x Screw M2.5 x 10 T8 PT THR
Lower dressing cap kit: 1x Lower dressing cap, 1x Spring, latch extension
HDI Nose cone transducer: Traditional 200 kHz High Chirp, 83 kHz Medium Chirp and DownScan 455 kHz, 800 kHz
Cable tie/heat shrink kit: 6x Cable tie anchored, 12x Cable tie small, 2x Heat shrink tubing 1.5”
GPS PCBA 1x PCB Test Assembely: 2x Screw, torx, no. 6 x 3/8, 1x GPS PCBA cable (not shown in the illustration)
2x Nose cone O-ring, 1x Cable tie/heat shrink kit (not shown in the illustration), 1x Column, inner, GHOST 47"/lower unit (pre-assembled)
Propeller hardware kit: 1x Thrust washer, 1x Propeller pin 1x M10 Propeller washer 1x M10 Nylock nut
Ghost® freshwater trolling motor 47", HDI Transducer, Compass
HDS-9 LIVE/PRO / Elite FS9 Bracket and Knobs