Magnobond Epoxy: 1x Magnobond Epoxy 63-1 50 ml

Lower unit rotor assembly: 1x Rotor assembly

Switch housing kit: 1x Switch housing, pedal, 2x Screw, no. 6x3/8, Phillips, pan, SS

Housing, lower, pedal kit, 47”: 1x Base, pedal, 1x Wiper seal, pedal, 3x Grommet wires pedal, 1x Cable tie/heat shrink kit (not shown in the illustration), 1x Misc. hardware, pedal kit

Damper gear assembly kit: 1x Damper gear assembly, 1x Screw, cap, M4x16, 1x Screw, no. 6x3/4, torx, pan, ss

Damper kit: 1x Damper, pedal, 1xScrew M4X8 socket cap head S/S 304, 1x Washer M4 flat OD 12mm SST, 1x PSA washer damper

Label, battery: 1x Label status panel w/adhesive, pedal

PCBA, battery kit, 1x PCB TST ASY power/battery potted, 1x Cable tie/heat shrink kit, 3x Screw 7 mm torx T8

Bottom plate, pedal kit: 1x Bottom plate, pedal, 2x Screw, M5x10 mm, hex, button, SS316, 8x Screw, no. 6x3/4, torx, pan, SS, 4x Rubber foot pedal

Pedal PCBA, potted assembly kit: 1x Potted main controller assembly, pedal, 1x Cable tie/heat shrink kit, 6x Screw M2.5 x 10 T8 PT THR

MISC. HARDWARE,MOUNT KIT

Lower extrusion kit, GHOST 47": 1x Lower extrusion, with bushing, GHOST 47"

Lower extrusion hardware kit: 2x Bolt, rear hinge, 4x Bushing, 1/2”, 2x Washer, M10, 316SS, 2x Jam nut, M10

Pushrod pin kit: 1x Pushrod pin 2x Pushrod pin clip

Latch trigger kit, GHOST 47": 2x Latch trigger, GHOST 47"

Front latch guide kit: 1x Guide, front latch, 1x Spring, extension, front latch

Front latch block: 1x Front latch block

Lower head adapter pin kit: 1x Pin bracket/bow arm, 1x Set screw, M6 x 8, SS

Secondary latch kit: 1x Secondary latch, 1x Spring, secondary latch torsion, 2x Washer, 1/2", nylon, 1x C-ring, 1/2", 15-7 PH SS, 1x Pull cable spacer

Upper extrusion kit with bushing, GHOST 47": 1x Upper extrusion assembly, GHOST 47"

Upper head adapter pin kit: 1x Pin, upper head, 2x E-clip, 1/2", 15-7 PH SS

Head adapter kit: 1x Head adapter with bushing

Pushrod kit, GHOST 47" 1x Clevis bracket 4x Screw, M5x8mm, hex, button, SS 1x Pushrod, finish machine with bushing, GHOST 47"

Lift assist spring kit, GHOST 47": 1x Gas spring, compression/traction, GHOST 47", 2x Binding barrel, 5/16 x 1”, Pan, PH, SS, 2x Screw, 1/4-20 x 5/16”, Pan, PH, SS