EXPLORER SERIES ICE POLE 12" EXT.

EXPLORER SERIES POWER HARNESS

Flush mount bracket for ActiveImaging™ HD transducers

HDS-16 PRO Bezel and SD Door

HDS-12 PRO Bezel and SD Door

HDS-9 PRO Bezel and SD Door

Extension Cable for Active Target

Ghost Active Imaging HD 3-in-1 Nosecone

ActiveImaging™ HD 2-in-1 Transducer.Provides ActiveImaging HD technology for SideScan and DownScan while leaving you free to select other transducer options for for Traditional/Chirp Sonar. 7.6m (25 ft) cable with 9 pin connector.

ActiveImaging™ HD 3-IN-1 delivers the highest-definition views of CHIRP, SideScan™ and DownScan Imaging™ in one transducer. Comes with a 7.6m (25ft) cable with 9 pin connector.

ActiveImaging™ HD 3-in-1 (High/Wide)– SideScan Fish Reveal. Delivers the highest-definition views of CHIRP, SideScan™, and DownScan Imaging™ in one transducer + SideScan Fish Reveal when connected to an S3100 sonar module.

HDS-10 PRO Suncover

HDS-10 PRO Bracket

ActiveTarget™2 Trolling Motor Shaft Mount

ActiveTarget™2 kit Includes Module,Transducer with 7.62 m (25 ft) cable, and Mounts

FLUSH MOUNT KIT: ELITE FS 9

ActiveTarget trolling motor mounting kit. Forward / down view

ActiveTarget trolling motor shaft mounting kit

The Prop Shaft Anode for the Lowrance Ghost® trolling motor allows for use in brackish water without voiding the Lowrance Ghost trolling motor warranty. The Prop Shaft Anode is a ring-shaped fitting that is installed over the existing propeller nut, on th

ELITE FS 7 with xSonic HDI M/H 455/800 Transducer (ROW) The new Elite™ Fishing System (FS) gives you access to the full line-up of Lowrance fishfinding tools – including ActiveTarget™ live sonar, Active Imaging™, FishReveal™ and preloaded C-MAP® Contour™

1x Cable, head to pedal, GHOST 52”, 2x Screw, M3 x 10, torx, 1x Seal, strain relief, 1x Cable tie/heat shrink kit, 1x PCBA thermal pad

HDI Skimmer® transducer 50/200/455/800kHz for Hook2* and Hook Reveal, with built in temp. Includes mounting bracket and hardware. Cable Length 6m (20 ft). Connector: 8 pin push fit. (* 50 kHz / Low CHIRP frequency options are not available on Hook2)

10lb. weight for shaft bearing pre-load

M32 Hollow tap for composite shaft replacement.